Driver Assist: Start-Stop & Hold v0.1

AutoHold and Start & Stop System for any Vehicle in BeamNG!

This Mod adds Autohold an System which holds ur Brakes on a Hold, and a Start & Stop System, which turns your Engine off at a Stop, and combines these two!

When you enable this Mod, the Mod is always active, im working on a Toggle Addition, so its planned but I can´t give any Date.

------------------------------------------------------------------------------------------------------------------
How it works:
When you come to a Stop,you Brakes automatically hold themselves. To release them again, just press the Gas Pedal.

If your Engine is hot enough: 60°c, after AutoHold holding the Brakes, you can Press the Brake Pedal again all through to the bottom (100%), and the Engine stops. To turn it on again (drive off) just press the clutch or gas pedal, and it turns on again.

There is a slight difference in needed input for turning the engine on and releasing the Brakes.
------------------------------------------------------------------------------------------------------------------
Releasing the Brakes (AutoHold) needs a throttle input of ~10%, whilst turning the engine on needs the clutch or a Gas Input of bigger than ~0%, so if ur stopped, and the light is turning green u can first already turn the engine on, and then drive off when traffic is clear.
------------------------------------------------------------------------------------------------------------------

For Manual: You cant disable the Engine if ur pressing the clutch, neither if ur not in Neutral.

Electric Cars, are not affected by this Mod, as it has a safety check mechanism, which checks if the car is electric, if it is, the mod is disabled for that car.